Possible to Purchase Replacement Knobs for Clubsport Shifter?
Ryan Carey Member
edited January 2020 in Fanatec Other
I recently had a move, and in the process I managed to somehow lose the knobs to my Clubsport shifter. I was simply wondering if it's possible to purchase replacement knobs? I know it's possible to purchase the limited edition carbon fiber knobs, but I would much prefer to purchase the original metal knobs. I've emailed the Fanatec sales department TWICE regarding this matter and I have yet to hear back from them. I'd really appreciate it someone from Fanatec could reach out to me. I'm debating whether to purchase a DD2 or not, but when the Fanatec sales department can't be bothered to even answer my emails it really puts a sour taste in my mouth. Hoping to hear back from someone from Fanatec. Thanks.
You can slap a sparco on there, no problem. @ $30 us it may even be cheaper then the incoming carbonium ones . im sure fleabay has knockoffs too.
the fanatec is actually the same thread. which came 1st the fanatec or the sparco?
Thanks for taking the time to respond. I really appreciate it. I was under the impression that the Sparco knobs have a slightly different thread. Have you popped on on yourself? I just remember seeing some threads on another forums where people had to do some drilling/etc. to get the knob to fit. It would be great if it just pops right on though. That would certainly be a very appealing alternative. Thanks again for your feedback!
depending on the knob,absolutely,. sparco has all types of wierdo products built all over indochina, so could very well be right. grab some digital calipers from harbor frieght for $10 and measure. the hubs though definitely accept the standard 6x70 And or the 3x configuration from momo or sparco.
this one is almost a dead ringer, but $80!
normally i would run down and measure that up for u ,but the batteries are dead in my calipers.
Using some calipers are a great idea. I'll certainly look into that. The knob is a bit on the pricey side, but it's certainly a great looking knob. Thanks again for your excellent feedback; I really appreciate you taking the time to help out.
Thread is M10 I believe
Hell yeah, there you go, people helping people! You know you can chat us up in discord if you like, we do that there too.
The threads are M12 x 1.5
Yup - this. :-)
Thank you very much. That's good to know.
Great. Thanks so much for the info!
☺️ Good to know about the discord. I really do appreciate the help!