Wheel doesn't center after start-up.
Viegaard
Member
Hello. I recently bought a ClubSport v 2.5 + ClubSport Formula V2 rim.
I have done this:
But after I start up my wheelbase (after it has been turned OFF)
It moves ever so slightly before the wheel-turning/spinning start-up sequence.
And it ends up here:
Being not levelled / even.
Any suggestions?
Best Regards, Thomas.
Side note:
I see two of these? Is this normal? Both ones take me to the same place and if I change the options in one, they save to both.
Comments
It's normal that the wheel is not centered after calibration.
As long as it shows 0 in the driver when it's physicaly centered everything is fine.
Just thought it was supposed to center itself after the start-up sequence.
Yes, when I have the wheel centered / levelled - To the best of what my eyes can see. It says 0, in the Tuning PC software thingy.
Itv was always the case that no Fanatec Wheel centers itself perfectly straight after boot. So everything is fine.
Any thoughts on my Fanatec Wheel Property Page showing 2 wheels/bases?
also normal, CSW V2.5 uses advanced electronics, so it is shown as 2 devices in windows. CSL Elite +, DD1 and DD2 are the same :)
Gotcha. Just a few of my friends only have 1 showing up. :) Was just curious.