New customer, new DD1 base and endurance button module not recognised after update

Peter Elliott

Hi guys I’ve just bought brand new Dd1 and attached my Porsche gt3 wheel podium hub, APM and Endurance button module. When attaching wheel the fanatec logo on Endurance module was on . I did the firmware update for dd1 and now the Endurance button module screen is blank when I go back in to the update screen it says drivers are up to date. On the fanalab screen the button module is not recognised either. Thought I would try to update the podium hub on its own but can’t figure out how to do that as saying drivers up to date. I’ve had a look on here and can see there’s beta files for hub, endurance button module but as I’m new to pc and base was hoping for advice from you guys on a way of getting PBME recognised.

Thanks in advance Pete

Sascha Kaymer

https://forum.fanatec.com/discussion/23013/new-customer-new-dd1-base-and-endurance-button-module-not-recognised-after-update

which driver package did you use to update?

Peter Elliott

Thanks for getting in touch will let you know in a minute

Peter Elliott

Hi it’s driver 400 and fanalab v 1 53

Sascha Kaymer

https://forum.fanatec.com/discussion/comment/64795#Comment_64795

please try driver 402 and update to Fanalab 1.54.5.

Peter Elliott

Thanks Sacha , should I remove cable between podium hub and endurance button module ? Before update

Sascha Kaymer

https://forum.fanatec.com/discussion/comment/64799#Comment_64799

with the new driver you don't need to remove the cable. just update the firmware in the order of the shown devices.