Activate Full Torque and check status without Fanatec wheel/base display

Thomas Noll

Hello,

is there a possibility how to activate (and check) the status for full torque?

With a Fanatec wheel => Look at the display and press a button

Without a Fanatec wheel => Look at the display and turn the wheel 90° to the left until the loading bar goes up

My situation:

I don´t have a Fanatec wheel AND I don´t see the display from my DD1 because my monitor is sitting lower. How can I activate/check the torque? Turning the wheel and hope that it is OK is not really a good option.

Can I see the status/loading bar in Fanalab for example or is there another possibility?

Thx in advance.

Maurice Böschen

It's not possible to see the High Torque status anywhere else. You have to look at the DD OLED Display.

Thomas Noll

OK - bad news but thank you. Then I know that I don´t have to search for a possibility anymore.

This would be a really important feature for FanaLab - I´m sure a lot of people does have this problem because they want their monitor as low as possible and then you don´t see the base at all...

Konstantinos Psarakis

Depends on how your base is mounted. If you mount it using the threaded holes on the side, nothing stops you from rotating it 180 degrees.

Mihai Vespasian

to OP... there is a way! If you listen to the base... when the low torque is on it makes a high pitched sound... hold the wheel 90* to the left... and when the high pitch sound turns off its in high torque mode.