CSL DD problem with firmware update being completed
I downloaded and installed the 429 drivers and noted that there was a new update for the CSL DD base. I followed the Firmware update software and the system and after spinning for several minutes it reports the base timed out or was disconnected. The base shows a flashing Blue light and the LOg txt file shows the update completed successfully but in the 3 sec countdown to reboot, the base disconnects before reboot. The base will not shut down by switch and requires power pull. Rebooted pc and restarted base and put it in PC mode red light and the pc does not see the base.😪
Comments
Here is the txt from the Log file:
Fanatec Wheel Base Updater Logs
Call: 11/1/2021 15:14:58
[START TRACE]
WHEELBASE_LOG: CPIC32UBLDlg::OnBnClickedButtonConnect >>
WHEELBASE_LOG: CSL Direct Drive Wheel Base detected
WHEELBASE_LOG: Please reset device and invoke bootloader
WHEELBASE_LOG: CPIC32UBLDlg::OnBnClickedButtonConnect <<
WHEELBASE_LOG: CPIC32UBLDlg::OnReceiveResponse READ_BOOT_INFO
WHEELBASE_LOG: Device connected
WHEELBASE_LOG: 0xEB7
WHEELBASE_LOG: 0x720
WHEELBASE_LOG: Selected firmware V1.0.3.2.release
has been loaded successfully.
WHEELBASE_LOG: CPIC32UBLDlg::OnReceiveResponse ERASE_FLASH
WHEELBASE_LOG: Flash Erased
WHEELBASE_LOG: CPIC32UBLDlg::OnReceiveResponse PROGRAM_FLASH Programming completed
WHEELBASE_LOG: Restarting Wheel in 3 seconds...
WHEELBASE_LOG: CPIC32UBLDlg::OnBnClickedButtonConnect >>
WHEELBASE_LOG: Device disconnected
WHEELBASE_LOG: CPIC32UBLDlg::OnBnClickedButtonConnect <<
WHEELBASE_LOG: 2 seconds...
WHEELBASE_LOG: 1 second...
WHEELBASE_LOG:
Firmware update completed successfully.
WHEELBASE_LOG: CPIC32UBLDlg::OnTimer Auto exit app after firmware update...
[END TRACE]
I connected the base to my Xbox One X and it functions properly however the my PC does not see the base.
Does your PC recognise the base in compatibility mode?