ClubSport V2 Base stuck in bootloader

Florian VoitelFlorian Voitel Member
in Wheel Bases (and Racing Wheels)

Hi,

I got the following Problem:

I built a new PC and so Installed the latest driver 450 for my CSW V2 with the Formula V1 wheel.

I got no FFB in ACC so It thought I should go back to the last released driver. Somehow i ended beeing stuck in the bootloader mode with the base (constantly flashing blue). I installed the 447 driver and tried to flash the frmware but the process is getting stuck in the state as shown in the screenshot.

Screenshot 2023-02-27 194019.jpg


I can`t turn off the base or do anything else. Also the Fanatec Controll Panel wont recognise the base anymore. Is there anything I can do or did I just f* it up?


Thank you for any help.

Comments

  • Florian VoitelFlorian Voitel Member

    In case anybody gets the same problem, I solved it by flashing the firmware from a different PC.


    Im not 100% sure but i think there are problems if the base is conected to usb 3.0 or higher. With my Laptop and USB 2.0 it was done in seconds.

Sign In or Register to comment.