Is there a bracket for CS DD similar to the one for the CSW v2.5?

David DeGreefDavid DeGreef Member
in Wheel Bases (and Racing Wheels)

I have a rig that is long in the tooth and the plate for mounting is not adjustable and slopes downward toward the driver.

The CSW v2.5 had a optional mounting bracket that would level the base.

Are there any plans to offer a similar type of bracket for the CS DD?

I would also like to ask the community that may have any ideas that would be a viable solution.

I suppose a wedge of wood might do the trick?

Thank you

image.png


Comments

  • Alessandro GortanAlessandro Gortan Member
    https://youtu.be/SjAl2NwagCE?si=teibfk2xhcLvxyfo


  • David DeGreefDavid DeGreef Member

    Thank you Alessandro I will have to check the dimensions on the plate side of the mounting but if it's not too wide that would be perfect.

  • David DeGreefDavid DeGreef Member
    edited December 2023

    Website does not mention the dimension from top of table clamp to overall top of unit. If someone has this it would be greatly appreciated if you could provide.

    Thank you

    image.png
    image.png


  • Alessandro GortanAlessandro Gortan Member

    You can measure it, knowing that the distance between the two holes is 80 mm.

    With a good ruler or better yet a caliper, measure the distance between the holes in the photograph, even directly on your cell phone. Then you measure the dimension you want to know, and do the proportion.

    It should be 27mm.

  • David DeGreefDavid DeGreef Member

    Received the Moza table clamp today and I don't think it could have worked any better.

    Thanks again AG for the tip, greatly appreciated.

    image.png
    image.png


Sign In or Register to comment.