Fanatec CSL DD Wheel Base disconnecting during drifting and F1
Samuel Stagg
Member
ok. I have had an issue simular like this but it is not the same.
When playing things like assetto corsa where I kind of have to lug the wheel around on my setup sometimes the wheel just disconnects and it is starting to piss me off a bit. It is fine in racing like gt3 but when drift and racing with F1 cars the ffb can be a bit more violent and the steering wheel just disconnects, If you have this issue or something simular please leave a comment on a solution if you know it, I have researched for a bit on how to fix the issue but haven't found anything. Not sure if it is like a loose power cable that disconnects when the wheel is lugged around or what but someone please help me with this issue.
Cheers
Comments
CSL DD 8nm or 5nm ?
i to been hear this disconnect here and there before already.
what drivers?
lower little bit the nm could help
i think some people use 80% nm for drifting
yeah i use 80%
i got the 8nm
that issue by default may come when user steers the steering wheel very fast left to right,
the voltage spike may jump over his limit what could cause disconnect
if lowering nm not help, you could have also hardware issue or we dealing here the firmware issue self
ill try fix the firmware fix on the fanatec software up rn and ill post back later to see if it fixed it
alright after a couple hours of racing where i purposefully went harder then usual it hasnt died yet, still havent tested drifting yet