GT DD Pro Wheel Base + ClubSport Universal Hub V2 not wokring/detected
Hi!
First up the setup:
GT DD Pro Wheel Base 8Nm
ClubSport Universal Hub V2 for Xbox
CSL Pedale
Before yesterday I hadn't used the stearing wheel for several months.
In the menus of GT7 on PS5 it worked fine for several minutes.
As soon as I started race, the paddle shifters stopped working right after a few seconds and the whole stearing wheel stopped working after around 30 secounds.
After that, the power LED was flashing red.
I connected it to my PC, but the Fanatec Control Panel didn't detect it.
I held down the power button for several seconds to force it into update mode. The Update worked, but now the power led was flashing blue and red. Control Panel still didn't detect it.
I took it of the power and let it sit over night. This morning it started fine and was detected by the Control Panel on PC. I updated all other firmware. Current status is:
PC Driver 455
Wheel Base 1.1.11.3
Wheel Base Motor 1.0.3.2
Wireless QR 6.0.1.1
The problem now is, that the steering wheel isn't detected (even though it worked fine yesterday before the whole wheel shut down). I tried the "Manual Firmware Update/Device Recovery" as suggested in the troubleshooting section in the Control Panel, but that didn't help.
Before today I hadn't removed the steering wheel since I first installed it. The pins look fine, none bent or corroded. The stearing wheel slides smoothly on the wheel base and locks propperly.
Any suggestions what the problem might be?
Is there anything else I can do?
Comments
that flashing thing what you say could be the shaft
it's looks like people like pull steering wheel very hard, and it comes out
also that plastic QR1is not very good self as well