issue with qr DD1
Baran Dogan
Member
im getting this error recently on my dd1 and my computer doesnt see wheelbase base screen is black. sometimes this error dont shown n working perfectly
Comments
I have exact same issue, only does it very rarely, once in 10-20 turn on cycles maybe.
I suspect that it has something to do with the Fanatec driver v452 - v455 Firmware for Base, Motor and WQR upgrade, as I had a few tries to get the WQR update to take at the time and this error only started after these updates, was running v451 for ages with no sign of this error.
• Podium DD1 / DD2 Base : 3.0.4.3 (NEW)
• Podium DD1 / DD2 Motor : 3.0.0.2
• Podium DD1 / DD2 WQR : 7 (NEW)
• CS SW Formula V2(X), V2.5(X) : 47 (NEW)
Currently running Fanatec Driver v463 with the same error still happening:
• Podium DD1 / DD2 Base : 3.1.0.7 (NEW)
• Podium DD1 / DD2 Motor : 3.0.0.2
• Podium DD1 / DD2 WQR : 7 (QR2)
• CS SW Formula V2(X), V2.5(X) : 47 (QR2)
I also have issues with Fanalab 2.x.x.54 locking up and / or completely shutting down whilst racing in Assetto Corsa (Original) resulting in the loss of my custom RPM LED's (F1 Wheel rim shows stuck static LED's , GEAR number or Speed most likely due to loss of Telemetry data).
I have no solutions either unfortunately.
That's normal.
not remember that i seen this with my DD2, and same time i not also use Fanalab, just saying
Has nothing to do with FanaLab. It is the WQR Module of the Base which sometimes does not properly boot when the base starts. So this error message then comes up every 20 to 50th boot or so. Unlikely to ever get fixed at this point, you just have to live with it..
the only time when i totally freeze my dd2 was when i used the itm in sdk
Aha
how it can be normal, that i not understand, it may ruin full race
How can it ruin full race when it only happens oocasionally when you start the base and then can get fixed by just restarting the base?!
you say it happens only at base start?
ok. i mixed with MadDog-IC talk about that second issue then.
any info about that normal thing, if it happen more often in older gen Intel pc than amd or newgen intel pc? or its just total random?
Totally random.
Hello i have a question,
when I start my wheelbase (DD1) my steering wheel is never in the center anymore,
I have to recalibrate it every time. even to activate my high torque and my steering wheel turns a quarter turn at 90°,
it is supposedly only at 78°. I read many issues with the software, hopefully this is also part of this problem.
Can this be remedied at this time?
Kind regards, Jeremy
you may have qr at wrong position
Where can i set my question?
you self tell its not center anymore , you may need check you Shaft if its correct position and tighten enoh based on manual what there is typed